Configure the PYNQ board (only once)

After flashing your SD card and before booting the PYNQ, we will first have to insert the SD card and check the charge level of the powerbanks.

The PYNQ will boot from the image that is on the SD and use the power that is provided by the USB connection. A diagram with all connectors is shown bellow:

Insert the SD card into the PYNQ

Insert the SD card into the PYNQ, taking care of the orientation (as shown in the picture):

You should feel a click when you push it in.

You can always leave the SD card in the PYNQ board, but be careful that it's not pushed out accidentally during transport.

⚠️ Warning

Do not pull out the SD card. To remove the SD card, push it in: it will then click and come out.

Continue

After inserting the SD card with the image and configuring your board, you can now connect it to your computer.